Introduction

Using the Web GUI it is possible to control your projects Exposed Properties and Layer selection via a web browser. The GUI is optimised for touch surfaces (tablets, phones etc).

You can also develop your own web GUI interfaces or control from remote web apps using the Web API on which the Web GUI is based.

Accessing the Web GUI

When enabled, exported Standalone Executables start a web server on port 8910.

To enable and access the Web GUI:

  1. Enable Web GUI in the project settings
    1. Project -> Settings
    2. In the General tab check ‘Web GUI Enabled’
  2. Export the project to a Standalone Executable
    1. Project -> Compile Standalone Executable
    2. Run the executable
  3. Access the GUI from a web browser
    1. Open a web browser
    2. Go to: http://127.0.0.1:8910
    3. The exposed properties will be displayed

You can access the Web GUI from any other computer via http://<ip_address>:8910

The GUI allows you to control exposed properties when the project is running as a Standalone Executable.